📖 This is a static documentation page. Open the interactive version with live canvas demos →

Mark an action

An action has three marks: what it is for, what carries it and whether it creates value. The passport of the operation breaks the piece time down by them.

On the canvas

The operation "Lathe work", the step "Load the blank", the action "Get the blank". On the right the "Properties" panel is open.

Steps

  1. Click the action "Get the blank". "Properties" shows three lists: "Target", "Carrier" and "Stream". Each says "Not set".
  2. In the list "Target" choose "Delivery".
  3. In the list "Carrier" choose "Physical".
  4. In the list "Stream" choose "Support".

Check

The three lists hold the chosen values. Nothing changes on the canvas: the marks are read in the passport of the operation, on the tab "Time structure".

If it did not work

The rule

"Stream" has three values: "Value", "Support" and "Waste". Until a stream is chosen, the time of the action stands in the passport as "Not set". The three marks are set independently: one does not change another.