Type in the soldering time
While the solder melts, the assembler holds the iron and waits: the hands are busy, but the duration is set by the process, not by movements. Such time is typed in as a number — in seconds.
On the canvas
The step "Solder the wires", the action "Solder a wire": "Move" — the iron is brought to the joint — and "Machine time", still empty. Under the action is a card with its time. On the right the panels "Properties" and, under it, "Result" are open.
Steps
- Click "Machine time". "Properties" shows the block "Value" with the tabs raw, sec, hr, t and the list "Mechanization" set to "Manual labour".
- In the block "Value" click the tab sec: the number is now typed in seconds.
- Type 3 and press Enter. The card gets a time in the row M, and H and P grow.
Check
The card of the action: M — 50.00, H — 51.62, P — 51.62. Before the soldering the row P was 1.62. Three seconds are 50 raw units.
If it did not work
- There is no block "Value" — "Move" or the action is selected. Click "Machine time".
- The row M is not 50.00 — the number was typed on the tab raw. Click sec and type 3 again.
- The number was not applied — you did not press Enter.
The rule
M is the time the process dictates, H is the time of the person. With the mechanization "Manual labour" the person is busy all that time, so the soldering went into H as well. There are two wires: the second is not drawn, the action gets a multiplier, as the screws did.