📖 This is a static documentation page. Open the interactive version with live canvas demos →

Set the thread and the count

The time of driving a screw depends on the thread, and the board has four screws. The thread is a number of the movement, the repetition is the multiplier of the action.

On the canvas

The step "Mount the board", the action "Drive a screw": "Take", "Install", "Rotate" (by screwdriver). Under the action is a card with its time. On the right the panels "Properties" and, under it, "Result" are open.

Steps

  1. Click the movement "Rotate". "Properties" has the field "Thread diameter, mm:", it holds 2, and under the field are its limits: (2 – 15).
  2. Our screws are M3: type 3 into the field and press Enter. The row P of the card grows.
  3. Click the action "Drive a screw". In "Properties", to the right of the name, is the field "x" — the multiplier, it holds 1.
  4. Type 4 and press Enter. The action on the canvas gets the badge x4: one screw is described, four are counted.

Check

The row P of the card was 5.28 raw, became 6.07 after the second step and 24.29 after the fourth.

If it did not work

The rule

Equal actions are not copied: one is described and given a multiplier. If the screw changes later, there is one place to correct.