📖 This is a static documentation page. Open the interactive version with live canvas demos →

Change the units of time

The same time can be read in the units of the calculation, in seconds, in hours and as ordinary time. The units are switched right in "Result".

On the canvas

The operation "Lathe work", the step "Bore the hole", the action "Boring": "Press by hand" and "Machine time" (500 raw). The panel "Result" is open in the bottom right corner.

Steps

  1. Click the action "Boring". "Result" shows the rows F, H, M, P, above them the tabs raw, sec, hr, t; raw is chosen.
  2. Click the tab sec. The same rows are shown in seconds.
  3. Click the tab t. The time is written in minutes, seconds and thousandths of a second.

Check

rawsect
M500.0030.000m 30s 000
P503.6030.220m 30s 216

If it did not work

The rule

One raw unit is 0.06 of a second. Units change only what is shown, the calculation stays the same. The rows Q, D, S are not time, they do not depend on the units.