Set the tightening torque
Screws are tightened to a given torque: a nominal value and a tolerance either way. That is how it is written on the tab "Controlled parameters" of the passport.
On the canvas
The operation "Assembly" with three steps. The panels are closed; their buttons are at the top of the canvas.
Steps
- Right-click the operation "Assembly", point at "Passport tab" and choose "Controlled parameters". The list has one parameter — "Tightening torque", so far with the interval 0…100 N⋅m.
- Click the row of the parameter and on the right, in the section "Basic", choose "Deviation" in the list "Value type". The fields "Min" and "Max" give way to "Nominal", "+ tolerance" and "- tolerance".
- Type 0.5 into the field "Nominal" and press Enter.
- Type 0.1 into each of the fields "+ tolerance" and "- tolerance", pressing Enter each time.
Check
The row of the list reads: VPcP-001, Tightening torque, deviation, 0.5 +0.1/-0.1 N⋅m.
If it did not work
- The right part says no parameter is selected — click the row of the parameter in the list.
- The row still reads +0/-0 — Enter was not pressed after the number. Press it in each field.
- The fourth step is not ticked — one of the two tolerance fields is filled.
The rule
The value type follows the way the requirement is given: "Interval" — from and to, "Deviation" — a nominal value and a tolerance. The unit and the physical sense of the parameter are set in the same section "Basic".