Add a controlled parameter
What is checked at an operation, and how, is written on the tab "Controlled parameters" of the passport. Add one parameter and set its limit.
On the canvas
The operation "Lathe work" with two steps. The panels are closed; their buttons are at the top of the canvas.
Steps
- Right-click the operation "Lathe work", point at "Passport tab" and choose "Controlled parameters". The list is empty.
- Press "+ Add parameter". A row with the code VPcP-001 appears in the list.
- Click that row. The fields of the parameter open on the right, the section "Basic" first.
- Type 20 into the field "Max" and press Enter. The interval in the row of the list becomes 0…20 mm.
Check
The row of the list reads: VPcP-001, interval, 0…20 mm.
If it did not work
- The right part says no parameter is selected — click the row of the parameter in the list.
- The interval in the row did not change — you did not press Enter.
- A second parameter appeared — the button was pressed twice. The steps do not depend on it.
The rule
A new parameter is made with ready values: the interval 0…100 mm, a sampling, a method of evaluation, a risk estimate. They are edited in the sections on the right. Under the list the section "Analytics" counts the parameters of the operation and shows what they lack.