Free the operator
The placement machine puts the components on by itself: the operator presses start and is free. Tell the editor so — and that the operator carries the finished board away while the machine runs.
On the canvas
The step "Place the components" with the action "Placement": "Press by hand", "Machine time" (30 seconds typed in — 500 raw) and "Move". Under the action is a card with its time. On the right the panels "Properties" and, under it, "Result" are open.
Steps
- Click "Machine time". In "Properties" the list "Mechanization" says "Manual labour", and on the card the row H (human) is greater than the row M (machine).
- In the list "Mechanization" choose "Automatic". The row H drops: the machine runs by itself.
- Click the movement "Move". "Properties" has the switch "Employment" with the caption "Overlapped"; it is off.
- Turn the switch on. The movement gets the badge O, and the row P of the card goes down.
Check
The card of the action, in raw units:
| F | H | M | P | |
|---|---|---|---|---|
| At the start | 1005.22 | 505.22 | 500.00 | 505.22 |
| After step 2 | 505.22 | 5.22 | 500.00 | 505.22 |
| After step 4 | 505.22 | 5.22 | 500.00 | 503.60 |
If it did not work
- There is no list "Mechanization" — a movement or the action is selected. Machine time has it.
- There is no switch "Employment" — the machine time is selected. Movements have it.
- The card did not change — the list kept its old value or the switch is off: a switch that is on is highlighted.
The rule
Mechanization decides how much of the machine's time the person is busy: with "Automatic" — none. Overlapping takes a movement out of the time per piece P but leaves it in the time of the person H: the operator does it, the board does not wait for it.