📖 This is a static documentation page. Open the interactive version with live canvas demos →

Fit movements into the machine's run

The machine runs by itself, and meanwhile the worker takes the finished part away. Such movements are done, but add no time per piece — they are marked as overlapped.

On the canvas

The step "Bore the hole" with the action "Boring": "Press by hand", "Machine time" (500 raw, automatic), "Take" and "Move". Under the action is a card with its time. On the right the panels "Properties" and, under it, "Result" are open: "Result" shows the time of what is selected, the card the time of the action.

Steps

  1. Click the movement "Take". In "Properties", under the name, is the switch "Employment" with the caption "Overlapped"; it is off.
  2. Turn the switch on. The movement on the canvas gets the badge O, and the row P of the card goes down.
  3. Click the movement "Move".
  4. Turn "Employment" on for it too.

Check

The row H of the card did not change: 5.55 raw. The row P was 505.55, became 505.22 after the second step and 503.60 after the fourth.

If it did not work

The rule

An overlapped movement stays in the human time (H) but does not enter the time per piece (P). The editor does not check what the movement coincides with: you turn the overlap on where the work really goes that way.