๐Ÿ“– This is a static documentation page. Open the interactive version with live canvas demos โ†’

Turn with a screwdriver

Screws hold the board. Work with a tool is a movement like work with a hand: "Rotate" has a variant for the screwdriver. Add it to the action.

On the canvas

The step "Mount the board", the action "Drive a screw" made of two movements: "Take" and "Install" โ€” the screw is taken and started. The palette "Microelements" is open on the left, the panel "Result" in the bottom right corner.

Steps

  1. In the palette move the pointer onto the row "Rotate": a list of variants opens beside it. Press "by screwdriver" in that list and, without releasing the button, drag onto the canvas โ€” the movement appears under the pointer.
  2. Bring it to the action "Drive a screw" so that the left edge of the movement lies on the label of the action. A red circle lights up โ€” release.
  3. Click "Drive a screw": "Result" shows the time of the action with the screwdriver in it.

Check

Right after the drop the new movement is selected, and its row P reads 4.50 raw. The action with three movements has 5.28 raw in the row P; without the screwdriver it was 0.78.

If it did not work

The rule

"Rotate" has four variants: "by hand", "by screwdriver", "by wrench", "flywheel". A tool is chosen as the variant of a movement, not as a separate element. On the canvas a movement of any variant carries the same label โ€” the variant is shown in "Properties".