๐Ÿ“– This is a static documentation page. Open the interactive version with live canvas demos โ†’

Read the assembly time

The sensor is assembled: the board in place, four screws, two wires. See how much time one sensor takes and which part of the work eats it.

On the canvas

The operation "Assembly" and its three steps: "Mount the board", "Solder the wires", "Check the sensor", each with its actions. The panel "Result" is open in the bottom right corner.

Steps

  1. Click the operation "Assembly". "Result" shows the time of the operation: the rows F, H, M, P, above them the tabs raw, sec, hr, t.
  2. Click the tab sec. The time for one sensor is in the row P, the soldering time in the row M.
  3. Click the step "Solder the wires". "Result" shows the time of this step alone, in raw units again.

Check

PM
"Assembly", raw138.51100.00
"Assembly", sec8.316.00
"Solder the wires", raw103.24100.00

If it did not work

The rule

"Result" shows what is selected โ€” this is how one finds where the time lies. Here 103.24 of the operation's 138.51 raw fall on the soldering: to speed the assembly up, start with it, not with the screws.