Connect with an arrow
An arrow appears when one node is dropped on another. Build a route of three nodes.
On the canvas
Three loose flow nodes: "Input", "Action" and "Output". The operation "Lathe work" is under them. The panels are closed, their buttons are above the canvas.
Steps
- Drag the "Action" icon onto the "Input" icon. A frame lights up around the "Input" โ release. The "Action" takes its place to the right of the "Input", and an arrow appears between them.
- Drag the "Output" icon onto the "Action" the same way.
Check
The three nodes stand in a row, the arrows run from left to right: Input โ Action โ Output.
If it did not work
- No arrow โ the node was released beside the target. The frame around the target must be lit at the moment you release the button. Drag the node once more.
- The arrow points the wrong way โ you dropped the "Input" on the "Action", not the other way round. Press "Start over" above the example.
Also useful
- An arrow from the "Input" can be drawn without moving the nodes: open "Properties", click the "Input", press "Connect flows" at the bottom of the panel, then click the node the arrow goes to.
The rule
An arrow runs from the node you dropped on to the node you dragged. A route describes one product: routes of different products are not connected with arrows.