Spread the stencil change
A stencil is changed once for a batch of boards, not for every board. Make the stencil change a setup and set the batch — one board will carry only its share.
On the canvas
The operation "Paste printing" with two steps: "Change the stencil" and "Print the paste". Under the operation is the card of its result. On the right the panel "Properties" is open.
Steps
- Click the step "Change the stencil". In "Properties" the field "Type" says "Main".
- In the list "Type" choose "Setup". On the card the row P goes down from 261.71 to 255.55, and the row ST gets 6.16 — the time of the stencil change.
- Click the operation "Paste printing". "Properties" now has the section "Parameters".
- Type 50 into the field "Min Batch Size" and press Enter. The row P1 becomes 255.67.
Check
The card reads: P — 255.55, ST — 6.16, P1 — 255.67. Before step 4 the row P1 read 261.71: the batch was one board, and the whole stencil change fell on it.
If it did not work
- There is no field "Type" in "Properties" — what is selected is not a step.
- There is no section "Parameters" — a step is selected. The batch size is set on the operation.
- The number was not applied — you did not press Enter.
The rule
ST is the setup, done once for a batch. P1 is the norm per board: P plus the setup spread over the batch. Loading the program into the placement machine and warming up the oven are written the same way.