Place the board precisely
In a device the parts are small and are put in with care: the board has to be aimed at the posts of the housing and seated. The more precise a movement, the longer it takes โ this is set by the conditions of the movement.
On the canvas
The assembly of a pressure sensor. The step "Mount the board" with the action "Board into housing" made of five movements. Under the action is a card with its time. On the right the panels "Properties" and, under it, "Result" are open.
Steps
- Click the movement "Install". In "Properties" its variant stands under the name โ "shaft/hole", and the lists of conditions follow.
- In the list "Degree of orientation" choose "High": the board is aimed at the posts exactly. The row P of the card grows.
- In the list "Connection density" choose "Tight": the board is seated with some force. The row P grows again.
Check
The row P of the card was 4.56 raw, became 4.93 after the second step and 5.09 after the third. The movement "Install" itself reads 0.98 raw in "Result".
If it did not work
- "Properties" has no such lists โ another movement is selected. "Install" has them.
- The card did not change โ the list was closed without a choice. Open it and click the line you need.
- The button "Start over" above the example returns the scene to its beginning.
The rule
The time of a movement comes not from a stopwatch but from its conditions: how precise, how tight, how convenient. In device assembly it is the conditions that tell one placing from another โ the movements themselves are the same.