Turn with a screwdriver
Screws hold the board. Work with a tool is a movement like work with a hand: "Rotate" has a variant for the screwdriver. Add it to the action.
On the canvas
The step "Mount the board", the action "Drive a screw" made of two movements: "Take" and "Install" โ the screw is taken and started. The palette "Microelements" is open on the left, the panel "Result" in the bottom right corner.
Steps
- In the palette move the pointer onto the row "Rotate": a list of variants opens beside it. Press "by screwdriver" in that list and, without releasing the button, drag onto the canvas โ the movement appears under the pointer.
- Bring it to the action "Drive a screw" so that the left edge of the movement lies on the label of the action. A red circle lights up โ release.
- Click "Drive a screw": "Result" shows the time of the action with the screwdriver in it.
Check
Right after the drop the new movement is selected, and its row P reads 4.50 raw. The action with three movements has 5.28 raw in the row P; without the screwdriver it was 0.78.
If it did not work
- The list of variants closed โ the pointer left the row past the list. Move onto the row again and go right, straight into the list.
- You pressed the row "Rotate" itself โ that makes the first variant, "by hand". Delete it with Backspace and take "by screwdriver" from the list.
- The movement lies on its own and there was no circle โ drag it onto the action once more: the editor tries the nesting by the left edge of what you drag.
The rule
"Rotate" has four variants: "by hand", "by screwdriver", "by wrench", "flywheel". A tool is chosen as the variant of a movement, not as a separate element. On the canvas a movement of any variant carries the same label โ the variant is shown in "Properties".