๐Ÿ“– This is a static documentation page. Open the interactive version with live canvas demos โ†’

Type in the soldering time

While the solder melts, the assembler holds the iron and waits: the hands are busy, but the duration is set by the process, not by movements. Such time is typed in as a number โ€” in seconds.

On the canvas

The step "Solder the wires", the action "Solder a wire": "Move" โ€” the iron is brought to the joint โ€” and "Machine time", still empty. Under the action is a card with its time. On the right the panels "Properties" and, under it, "Result" are open.

Steps

  1. Click "Machine time". "Properties" shows the block "Value" with the tabs raw, sec, hr, t and the list "Mechanization" set to "Manual labour".
  2. In the block "Value" click the tab sec: the number is now typed in seconds.
  3. Type 3 and press Enter. The card gets a time in the row M, and H and P grow.

Check

The card of the action: M โ€” 50.00, H โ€” 51.62, P โ€” 51.62. Before the soldering the row P was 1.62. Three seconds are 50 raw units.

If it did not work

The rule

M is the time the process dictates, H is the time of the person. With the mechanization "Manual labour" the person is busy all that time, so the soldering went into H as well. There are two wires: the second is not drawn, the action gets a multiplier, as the screws did.