๐Ÿ“– This is a static documentation page. Open the interactive version with live canvas demos โ†’

Set the tightening torque

Screws are tightened to a given torque: a nominal value and a tolerance either way. That is how it is written on the tab "Controlled parameters" of the passport.

On the canvas

The operation "Assembly" with three steps. The panels are closed; their buttons are at the top of the canvas.

Steps

  1. Right-click the operation "Assembly", point at "Passport tab" and choose "Controlled parameters". The list has one parameter โ€” "Tightening torque", so far with the interval 0โ€ฆ100 Nโ‹…m.
  2. Click the row of the parameter and on the right, in the section "Basic", choose "Deviation" in the list "Value type". The fields "Min" and "Max" give way to "Nominal", "+ tolerance" and "- tolerance".
  3. Type 0.5 into the field "Nominal" and press Enter.
  4. Type 0.1 into each of the fields "+ tolerance" and "- tolerance", pressing Enter each time.

Check

The row of the list reads: VPcP-001, Tightening torque, deviation, 0.5 +0.1/-0.1 Nโ‹…m.

If it did not work

The rule

The value type follows the way the requirement is given: "Interval" โ€” from and to, "Deviation" โ€” a nominal value and a tolerance. The unit and the physical sense of the parameter are set in the same section "Basic".