Add a tester
The sensor is checked with an instrument, and the instrument needs a check of its own — calibration. Measuring instruments are written on the tab "Equipment" of the passport together with their metrology.
On the canvas
The operation "Assembly" with three steps. The panels are closed; their buttons are at the top of the canvas.
Steps
- Right-click the operation "Assembly", point at "Passport tab" and choose "Equipment". The list is empty: "No equipment".
- Press "+ Add" and choose "Measuring instrument" in the list of kinds that opens. A row with the letter G appears in the list, and its fields open on the right.
- Type MT-10 into the field "PN" and press Enter. The part number appears in the row of the list.
- In the section "Specification", in the list "Metrological status", choose "Calibrated".
Check
Scroll the right part of the window down to the section "Verification / calibration / test": the switch "Subject to verification / calibration / test" is on, "Mode" is "Calibration", "Interval, months" is 12.
If it did not work
- No row appeared — the list of kinds was closed without a choice. Press "+ Add" again and choose a kind.
- There is no list "Metrological status" — another kind was chosen. Change it in the field "Type" on the right.
- The part number did not appear in the row — you did not press Enter.
The rule
A measuring instrument has fields of its own: the measuring range, the resolution, the permissible error. The status decides what it is subject to: "Calibrated" switches calibration on by itself and sets the interval.